Release Notes

Product: 	ENTTEC PIXELATOR MINI MK2
Product SKU: 	70068

--------------------------------------------------------------------------------------------------------------------------------------------------------------------------------
Note:    

- Please ensure you have the correct firmware for MK2.PIXELATOR MINI MK1 firmware is not compatible to MK2.
- It is strongly recommended to factory reset from the RESET BUTTON for a smooth firmware update before updating.
  In the case of the unit doesn't reboot successfully during the firmware update, follow the factory reset guide below will boot the device to the updated firmware.
  Factory Reset by Reset Button:
	- Power off the unit.
	- Press and hold the Reset button.
	- While holding the Reset button, power up the unit
	- Keep holding the button for approximately 3 sec.
	- Release the Reset button after the LED turns yellow.
	- Power cycle the unit.
- Following an update, power cycle your PIXELATOR MINI and clear your web browser cache (Ctrl+Shift+r) if using the same IP. 


--------------------------------------------------------------------------------------------------------------------------------------------------------------------------------

PIXELATOR MINI MK2 Release V1.0 10Dec2024 

  	-Initial Release

--------------------------------------------------------------------------------------------------------------------------------------------------------------------------------