Release Notes

Product: 	ENTTEC PIXELATOR MINI
Product SKU: 	70067

--------------------------------------------------------------------------------------------------------------------------------------------------------------------------------
Please check product serial number to load the compatible firmware versions:
- Pixelator Mini serial number using the following hex code format: 0050C20XXXXX - V1.12 only.
- Pixelator Mini serial number is a 7-digit numerical figure (e.g. 1234567) - V2.0 onwards.
 
Note:    

- It is strongly recommended to factory reset from the RESET BUTTON for a smooth firmware update before updating.
  In the case of the unit doesn't reboot successfully during the firmware update, follow the factory reset guide below will boot the device to the updated firmware.
  Factory Reset by Reset Button:
	- Power off the unit.
	- Press and hold the Reset button.
	- While holding the Reset button, power up the unit
	- Keep holding the button for approximately 3 sec.
	- Release the Reset button after the LED turns yellow.
	- Power cycle the unit.
- Following an update, power cycle your PIXELATOR MINI and clear your web browser cache (Ctrl+Shift+r) if using the same IP. 
- PIXELATOR MINI device in V1.12 is not compatible to Firmware V2.0.

--------------------------------------------------------------------------------------------------------------------------------------------------------------------------------
PIXELATOR MINI Release V2.3 6 May 2025 

	- Fixed a bug that receiving 2^31 unicast packets would force the device into boot mode.
	- Resolved issue where firmware updates could cause the device to get stuck during bootup.
	- Support for both unicast and subnet broadcasting artpoll reply
	- Improved IP address handling to ensure proper response when on the same subnet as the sender.
	- Fixed a stability issue causing the device to reboot under heavy network traffic (>50 Mbps).

--------------------------------------------------------------------------------------------------------------------------------------------------------------------------------
PIXELATOR MINI Release V2.2 7 Feb 2024 

	- Fixed total pixel count per port in overdrive mode
	- HTTP 1.1 update

--------------------------------------------------------------------------------------------------------------------------------------------------------------------------------
PIXELATOR MINI Release V2.1 16 Nov 2023 

	- Increased Universe capacity with overdrive mode, enabling 4U per output (total 32U).
	- Implemented Autofill for "Output Settings Options"
	- Implemented Preview Buffer on the home page as well as an auto-refresh function for the Preview Buffer.
	- Updated to HTTP 1.1
	- Fixed an issue where the device would get stuck during boot if sACN was selected as the input protocol and no Ethernet connection was present.
	- Boot updated to V2.1:
		- fixed an issue where the boot would not start up without ethernet connection
		- the status LED will now turn yellow when button is held for 3 seconds after boot-up to indicate that settings have been reset to defaults.
 

--------------------------------------------------------------------------------------------------------------------------------------------------------------------------------- 

PIXELATOR MINI Release V2.0  21 Dec 2022 (PIXELATOR MINI-GD32 from SN 2392325)

  	- Initial Release for GD32.
	- Updated webpage design.
	- Removed input protocol: Kling-Net
	- Added output protocol: GS8208B
	- Allowed custom timing and custom protocols.
	- Allowed up to 2 different output protocols.
	- Added Identification Test Mode.
	- Updated LED Indicator.
	- Updated DHCP logic.   

--------------------------------------------------------------------------------------------------------------------------------------------------------------------------------

PIXELATOR MINI Release V1.12  25 Feb 2022 (PIXELATOR MINI-MK60- last SN:0050C20845D6)

  	-Initial Release

--------------------------------------------------------------------------------------------------------------------------------------------------------------------------------